Introduction
Taking apart a Sunbeam stand mixer can be a daunting task, especially if you’ve never done it before. Fortunately, the process of breaking down the mixer isn’t as complicated as it may seem. With the right tools and a bit of patience, you’ll have your mixer taken apart in no time. This article will outline the steps you need to take to disassemble your Sunbeam stand mixer.
Step One: Unplug the Mixer
The first step in taking apart a Sunbeam stand mixer is to unplug the mixer from the wall outlet. This is an important safety precaution that should not be overlooked. This will ensure that the mixer does not accidentally turn on while you are taking it apart.
Step Two: Remove the Bowl
The next step is to remove the bowl from the mixer’s base. To do this, you’ll need to loosen the locking pin located on the underside of the bowl. This pin holds the bowl in place and must be loosened in order to remove the bowl. Once the pin is loosened, you can lift the bowl off the base.
Step Three: Remove the Beater
The third step is to remove the beater from the mixer. To do this, you’ll need to unscrew the beater from the shaft. This is easy to do with a Phillips head screwdriver. Once the beater is unscrewed, you can pull it off the shaft.
Step Four: Remove the Motor
The fourth step is to remove the motor from the base of the mixer. This will require you to unscrew the four screws located on the base. Once these screws are removed, you can lift the motor off the base.
Step Five: Remove the Shaft
The fifth step is to remove the shaft from the mixer. To do this, you’ll need to unscrew the two screws that hold the shaft in place. Once the screws are removed, you can lift the shaft off the base.
Conclusion
Taking apart a Sunbeam stand mixer is not as difficult as it may seem. With the right tools and a bit of patience, you can easily take apart your mixer without too much trouble. Once your mixer is taken apart, you can clean it and then reassemble it for use.
Frequently Asked Questions
FAQ #1: How do I take apart a Sunbeam stand mixer?
Answer: Before taking apart your Sunbeam stand mixer, unplug the power cord from the electrical outlet and disconnect all parts from the mixer. Then, turn the mixer upside down and unscrew the four screws located at the bottom of the stand. Once the screws are removed, the bottom part of the stand should lift off and you will be able to access the internal components.
FAQ #2: What tools do I need to take apart a Sunbeam stand mixer?
Answer: To take apart a Sunbeam stand mixer, you will need a Phillips head screwdriver, a flat head screwdriver, and a pair of pliers.
FAQ #3: What components are inside a Sunbeam stand mixer?
Answer: Inside a Sunbeam stand mixer, you will find the motor, gears, a speed control lever, and a power switch. You may also find a variety of attachments depending on the model of your stand mixer.
FAQ #4: How difficult is it to put a Sunbeam stand mixer back together?
Answer: Putting a Sunbeam stand mixer back together is not difficult, but it can take some time to align all of the parts correctly. Make sure to refer to the instruction manual for your specific model so that you can reassemble the mixer correctly.
FAQ #5: How often should I clean my Sunbeam stand mixer?
Answer: You should clean your Sunbeam stand mixer after each use to ensure that it remains in good condition. Make sure to wipe down the exterior of the mixer as well as the attachments with a damp cloth to remove any food particles or residue.